Surface-mounted bulb / tube Weatherstrip Profile

What this profile class means

Profile family: Compression seal
Profile subtype: Surface-mounted bulb / tube
Common application context: door, window
Contact mode: compression
Seal body: bulb or tube
Mounting interface: surface-fastened

Compressible tube/bulb is attached to a face/flange or carrier fixed to a frame surface.

Common terminology that may lead to this class includes: surface-mount bulb, tubular gasket, surface gasket. These terms are discovery clues only; they do not prove fit.

Identification order

1. Confirm the installed location and motion: door jambs; window stops where specified.
2. Identify the mounting/receiver interface before judging the outer body shape.
3. Inspect an end-view cross-section and note orientation, mirrored/asymmetric features, fibres, chambers, leaves/flaps, carriers, or fasteners as applicable.
4. Measure the critical fields below using the the measurement datum and tool-resolution rules and preserve uncertainty.
5. Compare only against records with compatible interface geometry. Treat visual similarity as a clue, not as compatibility evidence.
6. Keep product identity and replacement fit as separate claims under this evidence policy.

What to measure

• body diameter/reach — capture as an observed/measured field; do not invent a value.
• flange/carrier width — capture as an observed/measured field; do not invent a value.
• fastener method — capture as an observed/measured field; do not invent a value.
• orientation — capture as an observed/measured field; do not invent a value.

Also record the measurement tool, resolution, repeated readings where practical, sample condition, original reported value/unit, and measurement notes. If a critical field cannot be measured safely or reliably, leave it UNMEASURED rather than guessing.

What not to infer

Do not infer screw/nail spacing or gap capacity without a product specification.

Additional guardrails:

• Do not infer brand/model compatibility from a family name or silhouette.
• Do not infer a universal dimension from terms such as “kerf,” “T-slot,” “pile,” “bulb,” “sweep,” or “felt.”
• Do not infer material composition unless it is marked, directly observed at the generic class level, or source-backed.
• Do not publish a fit/supersession statement without explicit authoritative evidence for that relationship.

Evidence and provenance

This page uses source-backed profile taxonomy, measurement rules and evidence boundaries. The site structure does not broaden the scope of the cited sources or establish exact replacement fit.

• Source — Maryland Energy Administration, Weatherstripping — https://energy.maryland.gov/residential/pages/technicalassistance/weatherstripping.aspx — supports: Generic tension/V-strip, felt, pile, foam tape, reinforced foam, tubular gasket and door-seal terminology; application distinctions.
• Source — Schlegel, Weatherseal products: Q-LON, pile & extruded seals — https://www.schlegel.com/products/ — supports: Compression foam gasket, brush pile, fin-pile, extruded-seal technologies; kerf/surface/carrier fitment distinctions.

Useful next steps

• Compression Weatherstrip Profiles — Profile family
• Measure Bulb & Compression Weatherstrip — Measurement guide
• Door Weatherstrip Identification — Application guide
• Window Weatherstrip Identification — Application guide
• Weatherstrip Terminology Guide — Terminology guide
• Weatherstrip Identification Methodology — Methodology

Integration note

Use the Weatherstrip Reference exactly as written. Do not create an alias page for the common terms above. Any original illustration used on this route must remain labelled “Reference graphic — schematic, not exact product depiction” unless a later exact record binds geometry to evidence.